![]() Continue this process down the entire length of the cup for each color.For the second layer, apply the same amount of thickness of the Coral alcohol ink.Apply about 10-15 drops of the Fiesta alcohol ink toward the top rim of the cup (about 1-1.5 inch thickness).Finally you can put a vinyl phrase or drawing if you wish. Once your tumbler is dry, I recommend that you wash it before using it. If you find it necessary, you can repeat the process to give your tumbler an extra layer of epoxy resin. If you slow down the tumbler turner too quickly, the epoxy can drip and not dry evenly. Once the resin stops dripping, you can turn off the motor but leave the tumbler in place for approximately 24 more hours. If you wait until the resin dries, the tape could get stuck or leave marks on the tumbler.Īfter removing the tape, let the tumbler continue to spin until the resin is dry to the touch, this takes approximately 4 hours. When you have finished pouring the resin into your tumbler, wait 10-20 minutes and remove the tapes you put on earlier. To remove the bubbles, use heat, which can be from a heat gun or a blowtorch. ![]() It is normal for some air bubbles to rise to the top of your epoxy. You can use a wooden stick, your gloved finger, or a silicone brush to spread the resin gently.īe sure to cover your tumbler completely, except for the places masked with painter’s tape. Place your tumbler on the turner and while turning, slowly pour in the resin. Step 5: Apply the resin to your tumbler.Then divide this into as many smaller containers based on how many colors you want to use. Use a stick to stir gently, being careful not to stir too quickly so bubbles don’t form. Measure the resin components in equal parts (I recommend you to use a measuring cup) and then pour both into a bowl to mix them well. Epoxy resin comes in two parts: part A is the resin and part B is the hardener. Remember to place paper under your tumbler while you sprinkle it with glitter so that you can save the excess and use it for other projects.īefore mixing the epoxy resin it is important to add painter’s tape to the inside edge of the cup to prevent the dripping of resin into the cup.Īlso, if you’re going to drink directly from the tumbler, make sure your resin is food-safe or mask the top rim on the outside of the tumbler with tape as well. If the glitter doesn’t cover enough, you can repeat this process after the Mod Podge dries. For the second method, apply a layer of Mod Podge to the outside of the tumbler and generously sprinkle glitter all over the surface of the tumbler until completely covered. You can buy glitter paint directly or make it with Mod Podge and glitter. Once you have the tumbler painted, it’s time to add glitter! If you don’t want a glitter tumbler you can skip this step of the tutorial. To paint you can place the tumbler in the turner. Try not to apply too much paint so that it does not spill. Using the spray paint of your chosen color, spray in short, quick bursts until the tumbler is completely covered. Once you’ve finished protecting the areas you don’t want to epoxy, paint the outside of the tumbler if you like. It is recommended to mask the edges of the tumbler that are plastic. You can also mask your tumbler with painter’s tape if you want any part of it to be without epoxy. Start preparing your workspace, cover your work table with plastic or old newspapers. Step 1: Prepare your work surface and tumbler.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |